Installation Instructions:

1. *Remove 4 screws holding windshield in place.

2. *Remove 2 screws immediately under the windshield.

3. Remove mirrors and unplug turn signal bulb housing, disconnect wires to bulb holder.

4. Remove 12 screws holding instrument panel cover in place.

5. Pry and pop loose the panel cover.

6. *Disconnect (up to 4) electrical connectors at left rear of panel.

7. Remove mirror-mounting bolts (3 on each side). (#2 below)

8. Insert t/signal wires thru large hole of bracket, and position brackets in place, securing with mirror mounting bolts. (#1 & 2 below)

9. Install wiring harness for driving lights, running +/- wires thru same hole as turn signal wires.

10. Mount and finish connecting your driving lights and reconnect your wiring harness to left rear of dash panel cover.

11. Remount your panel cover *(12 screws in panel face + 2 screws in the front of the fairing). (#1 below)

12. Reconnect your t/signal bulb housing to wiring harness and plug into mirrors.

13. Place a couple pieces of ¼" foam tape adjacent to the three mounting-bolt heads.

14. Remount your mirrors. (#3 below)

15. Remount the windshield. * and (#1 below)

16. Go have a nice day.

  (1) When fastening any part, you must follow the Mfg.'s torque spec. (2) 3mm Allen socket, 8mm-open/box-end wrench and long needle-nose pliers suggested. (3) Depending on the gauge of the wiring, you should be able to run them thru the gap between the mirror and the bodywork. Don't forget to install a quick-disconnect, somewhere here.

*Steps annotated with an asterisk (*) may not fully apply to the R1150RT.